7
Notes
•
When the doorbell flashes blue quickly, it is powered on. Continue
doorbell setup.
If the doorbell does not power on, verify the electricity is off, and
then check the wiring.
•
Due to the
internal “chime” battery charging requirements, first time
doorbell chime operation may take up to 3 hours
10. Use CVP app to join the doorbell to the network.
a. Connect your smartphone to target Wi-Fi network.
b. Open the CVP app.
c. Tap
Scan QR Code
.
d. Scan QR code from CVD button or from label on the cover of this
quick start guide.
e. Tap
Connect to Network
.
f.
Tap the
Next
button if CVD is flashing blue, otherwise reset the
CVD by pressing and holding the reset button until the voice prompt
states,
“Reset Successfully”.
g. If not already connected to target network, tap
Change Network
and follow the onscreen prompts to connect to the target network,
otherwise enter network password and tap
Next
.
h. The app connects to the CVD AP network.
i.
If it fails, tap
Cancel
and then tap
Configure Wi-Fi
.
i.
Find the associated AP network SSID
ClareCVD_serialnumber
and forget the network.
ii.
When the network reappears in SSID list, tap on it and enter
the network password
ClareCVD_verificationcode
, the
verification code is located on the label affixed to the front of
this quick stat guide. It is 6 uppercase alpha characters.
iii.
After connecting to the AP network, wait for app device to
prompt you to allow network connection without internet.
Note:
UI and messages for this differ from phone to phone.
If not accepted, the app device will not stay connected to
the AP network and CVD configuration does not complete.
If this occurs, forget the network and rejoin according to
steps i.ii and i.iii above.
