Clare Controls CM-MT8810-BT-70, User Manual, Page: 27 / 40

HDBaseT 8x8 Matrix Switcher User Guide 21
%9963. Check the working mode of infrared carrier.
%9964. Check the IP address.
%9971. Check the connection status of the inputs.
%9972. Check the connection status of the outputs.
%9973. Check the HDCP status of the inputs.
%9974. Check the HDCP status of the outputs.
%9975. Check the switching status.
%9976. Check the output resolution.
%9977. Check the status of digital audio of output channels.
%9978. Check the HDCP status of the input ports.
Notes
 Disconnect all the HDBaseT cables before sending the command
EDIDUpgrade[X].
 In above commands, the [ ] symbols are for easier reading and do not need to
be typed in the actual operation.
 Remember to end the commands with the ending symbols “.” and
“;”.
 Type the command carefully. It is case-sensitive.
Control the switcher
To control the switcher, you must connect its 9-pin female RS232 port to the PC’s
RS232 port, or you can just connect any one of the HDBaseT receiver’s RS232 ports
to the PC. The RS232 command transmits to the switcher via the twisted pair. Use
the RS232 control software to control the switcher.