HDBaseT Receiver 70m User Guide
3
System connection
Usage precautions
•
System should be installed in a clean environment and have proper temperature
and humidity controls.
•
All of the power switches, plugs, sockets, and power cords should be insulated for
safety.
•
All devices should be connected before powering on.
•
The Cat5e/Cat6 terminations for HDBaseT devices should be a straight-thru
TIA/EIA T568B standard.
Application examples
The CM-BT10-RX70 HDBaseT receiver works in conjunction with the CM-BT10-TX70
HDBaseT transmitter or an HDBaseT matrix switch, such as the CM-MT4410-BT-70.
By transmitting signals across reliable Cat5e/Cat6 cables, the video signal may be
used at far greater distances from the source device than would be capable with
traditional HDMI cables. Additionally, control signals can be sent bi-directionally across
the same Cat5e/Cat6 cable. The following figures show you some application examples
for use of the CM-BT10-RX70 receiver.
Note:
When using a control system, such as Clare Controls, Crestron, or URC to
transmit IR control to the receiver via HDBaseT, a 3.5mm female mono to 3.5mm male
stereo adapter cable must be used. The female mono end connects to the control
system; the male stereo end connects to CM-BT10-TX70 or CM-MT4410-BT-70.
