© 29SEP16 Clare Controls, LLC.
1 / 4
Doc ID - 904 • REV 06
CLIQ.express Controller Installation Sheet
Last modified:
09/29/16
Description
The CLIQ.express is Clare Controls’ entry-level controller for
home automation that integrates a broad range of common
interface elements into a single unit. It provides device
management services to AppModules, supports Clare user
interface services, and acts as the gateway to the ClareCloud
for system updates. The controller comes complete with the
ClareOS and all AppModules preloaded.
Note:
Models, and their appearance, are subject to change
without prior notice.
WARNING:
Any changes or modifications made to this product
not expressly authorized by the manufacturer could void the
user’s right to operate this device.
Unpacking the CLIQ.express
Remove all contents from the CLIQ.express packaging and
ensure you have the following items.
1 × CLIQ.express device
1 × power supply
1 × RJ12 to DB-9 cable (null modem)
1 × antenna and extender cable
4 × rubber foot covers
Record the device’s UUID number (labeled on the bottom of
the device) on the line below, or scan the QR code (also on the
label) with a scanning app, and then email the number to your
system programmer. Your system programmer will need this
UUID information to configure the CLIQ.express device.
UUID: __________________________________
Do not use this UUID for more than one account.
WARNING:
Do not apply power to the CLIQ.express until
installation is complete. Failure to do so may result in bodily
injury and/or damage to the equipment.
Installation
The CLIQ.express can be mounted in a structured enclosure,
set on a rack shelf, or placed in any room near your devices.
Note:
The CLIQ.express contains a 908.4 MHz transceiver. To
prevent radio frequency (RF) interference from external
sources, we recommend that you place the CLIQ.express
away from devices that may cause interference and away from
conductive metals.
Mounting the CLIQ.express in a structured
enclosure
When mounting the CLIQ.express in a structured enclosure,
we recommend using the Leviton Structured Media Enclosure
or the Suttle SOHO Access Enclosure panels fitted with the
ClareHome Structured Enclosure Extender (P/N CH-EXT-28
and CH-EXT-42) for added protection against heat build-up.
(Panels and extenders are sold separately.)
To mount the CLIQ.express in a structured enclosure:
1. Place the CLIQ.express inside the structured enclosure
with the rear of the device facing up. See Figure 1.
2. Using cable ties, secure the CLIQ.express to the
enclosure.
Note:
Be sure to leave at least 1U of spacing (1.75 in.
(4.45 cm)) above and below the CLIQ.express when mounting.
Figure 1: CLIQ.express mounted in a structured enclosure
(1) Mount CLIQ.express with cable ties
(1)
