QTY. PART NO. DESCRIPTION
2
103403
RUNNER, .3/8 X 2-1/2 X 56 LG
1
103422
INSTRUCTION, RUNNER KIT
1
101550
KIT, HARDWARE RUNNER
(includes the following)
30
102516
SCREW,10-24 X 1" PTHMSSS
30
101548
NUT, 10-24 NYLOCK SS
30
101549
WASHER, #10 FENDER SS
Runner Kit Installation
For: Scout, Pro, Legend, Thermal and Trapper models,
CUT THE RUNNERS TO 40
” in length.
For: Nanook, and Guide models,
NO CUTTING IS REQUIRED
.
1.
Position the strips on the base. Using a 3/1
6” or slightly larger drill bit, drill a hole through runner strip
and base starting at the curved end of the base.
2.
Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the
curved area before drilling the next hole
(
If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to
make the Strips more pliable before drilling.)
( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)
3.
Drill next hole through the runner strip and base and slightly tighten fastener to hold the runner in
place.
4.
Keep repeating this procedure
EVENLY SPACING
the remaining holes and securely tighten all
fasteners once they are all installed.
5 .
Repeat same process for remaining runners.
PARTS LIST
START HERE
56
”
SCOUT, PRO,LEGEND,THERMAL AND TRAPPER
NANOOK AND GUIDE
40
”
START HERE
Scout, Pro, Trapper, Legend Thermal
Nanook, Guide
