‑ 0 ‑
RePlaCING THe UlTRaCaRB CeRaMIC FIlTeR
When the flow meter’s red warning light flashes,
replace your old UltraCarb Ceramic Filter with a
new filter.
1.
Follow steps1, 2 and 3 under “Cleaning the
UltraCarb Ceramic Filter.”
2.
Discard the used UltraCarb Ceramic Filter.
3.
Follow steps 6 through 12 in the CleaNING THe
UlTRaCaRB CeRaMIC FIlTeR section.
4.
Insert the replacement UltraCarb Ceramic Filter
into the base by applying a downward
pressure, then twisting the UltraCarb
filter to slide it into place (
Figure 10
).
5. Turning clockwise, screw the Filter
Housing back into the Base Assembly.
6.
Position the filter so that the water spout
points into the sink. Each time a new
UltraCarb Ceramic Filter is installed, run
cold water through the filter for several
minutes to remove any small carbon
Figure 10
