Clabo Gemma J G12, Technical Book

Page: 19 / 43

Gemma J Ice Cream Cabinet
English
pag. 19
To visualise or change the set point. When programming this button is used to select a
parameter or to confirm a value.
This button is used during programming for going through the parameter codes or for
increasing their value.
If pressed and then released you will visualise the controlled section (LOC, SE2, ALL).
If pressed continually for 3 seconds this button allows you to gain access to the sections
menu.
This button is used during programming for going through the parameter codes or decreasing
their value.
Keep this button pressed for 3 seconds to start the manual defrosting cycle.
Use this button to turn the display cabinet lights on and off.
Turn the cooling system on/off.
Keys Combinations:
+
Press and hold together for three seconds: enter the programming mode
+
Press and release together: exit from programming and return to temperature
visualization
There are a series of luminous points on the display, the meaning of which you will find in the table below:
LED Mode Function
ON Compressor on
FLASHING
Programming phase (flashing with LED )
ON Evaporator fans active
FLASHING
Programming phase (flashing with LED )
ON Defrosting active
FLASHING Dripping time underway
ON
ALARM SIGNAL
- In the “Pr2” programme it indicates that the parameter is also
present in “Pr1”
4.11 S
ETPOINT VISUALIZATION AND
C
HANGE
(
OPT
.
“B”)