Claas TUCANO 2017, Information And Basic Field Settings

Page: 22 / 40

21
2. Check the height of the auger within the trough of the cutterbar. There should be a
minimum gap of 20mm between the trough and the auger flights.
3. Remove the intermediate retractable fingers along the length of the auger leaving
just the middle ones.
4. The speed of the auger can be slowed by the fitting of optional sprockets on the chain
drive shaft.
Cutterbar
Adjustments
Skids
The skids underneath the cutterbar
should be set to suit the local conditions
e.g. stones, loose soil. It is recommended
that they are lifted right up in abrasive
conditions.
With this header we now have an
increased sized auger (660mm) which
aids in bringing in a even crop feed.