User & Installation Manual: CLAAS Trackmaster device
Ver-6.1.4(DATE- 23/10/2015)
4
D. Checks after installation and connection:
Once the device has been installed & connected with machine wiring properly, the three LED on the device will start
blinking as describe below. Please note that it may take up to 20 minutes for all three LED to be “On”. Upon initial power
up, this is due to the searching of device for GPS/GSM signals, establishing itself on the GSM Cellular network and running
other diagnostics/ set-up routines.
1.
Power (Green)
If LED is blinking: Device is powered on.
2.
GSM LED (Red)
If LED is blinking with equal ON-OFF time: Device is still
registering to GSM, no SIM Card inserted or no network.
If LED while blinking with short ON and Long OFF time holds
on: Either GPRS service is not for more than 3-5 seconds
available or GPRS is not activated on SIM card.
If LED is blinking ON-OFF continuously e.g.2-3 times in 1 sec,
then devices is connected to HOST.
3.
GPS LED (Amber)
If LED flashes: Device has acquired valid GPS signal.
If LED is OFF: GPS signal is either not available or the system is in process of acquiring the GPS signal
Though it is not recommended, But still if user wants to install the preferred GPRS activated SIM card, then
User has to communicate 10 Digit SIM number with APN to dealer to configure it with the VTS device. User
has to pay separately to new SIM service provider and has to ensure for the SIM services for proper working
of VTS Device
Request needs to be raised before installing the preferred GPRS activated SIM card to the VTS device.
It is recommended that trained personal at dealer do this activity.
E.
New SIM card installation instruction:
Preparation
In order to install new SIM in VTS device properly, the following preparations should be carried
out:
• Prepare one operational GSM SIM Card. Make sure that the SIM Card:
—
Can operate without PIN protection.
—
Place SIM card in the mobile and check whether GPRS service is activated or not.
—
Once GPRS service is activated, ask the local service provider for APN
—
Communicate 10 Digit SIM number with APN to dealer to configure it with the VTS
device
Insertion of SIM in VTS Device
—
Disconnect the vehicle battery and observe other Vehicle manufacturers
safety instructions.
—
Before insertion of SIM card firstly remove the 6 pin connection from
machine electrical.
—
Open the VTS Device from the back side, by opening 8 screws using
screw driver as shown.
—
Now press the SIM slot slightly in the direction of Unlock shown.
—
Now insert new SIM card and lock the slot by pressing the slot in lock
direction.
—
Close the VTS device securely without damaging the seal used for water
proofing of the device and tighten the 8 screws using screw driver.
