Claas LEXION 480, Repair Manual

Page: 340 / 1018

5.3.10
RHB LEXION 480 - 188 678.1
Grain tank unloading
Turn out the vertical grain tank unloading auger to the
bottom.
(Fig. 31)
Installing the vertical grain tank unloading
auger
1. Turn the vertical grain tank unloading auger into
the machine from the bottom.
CAUTION!
The vertical auger must be offset by 180° ,
relating to the horizontal auger in the grain tank
unloading tube. The two flight ends must not
touch each other. Check correct position by
turning the augers.
To prevent the auger from dropping out
unexpectedly, rotate the auger so that the flight
end is not near the gap (S).
(Fig. 29, 31)
2. Insert the bottom angle drives and bolt them
down.
3. Refit both grease pipes to the angle drive.
4. From serial no. …:
Slide on sprocket and align it to the measured
dimension, then secure gib head key.
(Fig. 32)
Up to serial no. …:
Slide on shims and sprocket. Insert circlip.
(Fig. 16)
31
32