Claas LEXION 480, Repair Manual

Page: 181 / 1018

188 678.1 - RHB LEXION 480
3.3.21
Accelerator
On the right-hand side, place the first tapered ring (23)
on the shaft with semi-fluid lubricant. Then install the
parallel key (24) and the hub (25) on the shaft.
Slide the second tapered ring (26) onto the shaft,
again ensuring sufficient semi-fluid lubricant is applied,
then insert washer (27) and bolt (28) on the face end of
the shaft and tighten.
Tightening torque = 180 Nm
(Fig. 50, 60)
Bolt down the V-belt pulley (29) to the hub (25) with
bolts (30).
Tightening torque = 110 Nm
Connect the cable to the magnetic pick-up (G).
Check dimension (X) = 1 ± 0.5 mm according to
Fig. 51.
(Fig. 50, 61)
Install the V-belt (K) and adjust it – see page 7.3.11,
Installing and adjusting the accelerator drive belt (24) .
(Fig. 62)
Install the V-belt (R) on the left-hand machine side and
adjust it – see page 7.2.2,
Installing and adjusting the
cutterbar drive belt (1) (Cutterbar drive without varia-
ble-speed drive)
and/or – see page 7.2.4,
Installing
and adjusting the cutterbar drive belt (2) (Cutterbar
drive with variable-speed drive)
.
(Fig. 63)
60
61
62
63