174
00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
10 Fieldwork settings
10.2 Feeder unit
67086
10.2 Feeder unit
82118
10.2.1 Adjusting the cutting height indicator
The sender (1) for the front attachment cutting height
display on the right feed rake conveyor side must be
adjusted. It shows the front attachment cutting height
above the ground.
– Prepare fieldwork.
– Check the cutterbar float springs.
– Start the diesel engine.
– Switch on the road travel / fieldwork switch.
– Lower front attachment until the skids are 100 mm
above the ground.
– Observe the general warnings at the beginning of
the "Fieldwork settings" chapter.
– Slacken off bracket (2) and adjust it so that the
pointer on the cutting height indicator (A) stands at
the mark (9).
– Bolt down bracket (2).
79341
10.2.2 Adjusting the scraper profiles
The scraper profiles influence the material flow in the
feed rake conveyor. The scraper profiles must be set
for grain or maize.
– Observe the general warnings at the beginning of
the "Fieldwork settings" chapter.
– If required, turn scraper profile (1) at the feeder
unit and bolt down hand-tight.
– Fit front attachment to the machine.
– Adjust scraper profile (1) according to the front
attachment scraper profile and bolt it down.
1
19602
2
19601
2
1
9
A
B
3
19521
1
Warning!
Sharp edges and pointed machine parts.
Slight injuries.
– Wear safety gloves.
Crop
Scraper profile bolts down
to feed rake conveyor with
Grain
narrow leg
Maize
wide leg
