Claas CORTO 250, Service Parts

Page: 82 / 130

Hydraulic / Electric System LINER TIC
4-22 10/04
1.3.6 Setting the
sequential control
on the turning area
The sequential control defines the time delay by which the rear rotors are
lowered or raised as compared with the front rotors.
Before the first use, the control unit can be adapted to the individual
ground speed.
Lowering the rotors: Briefly press key 9 when driving on the turning area.
After this (within 3 seconds), press and hold key 6.
The rear rotors will fold down only after this key is released.
The time between lowering the front rotors and lowering the rear rotors
has now been stored.
Raising the rotors: Briefly press key 9 when driving out of the turning area.
After this (within 3 seconds), press and hold key 6.
The rear rotors will fold up only after this key is released.
The time between raising the front rotors and raising the rear rotors has
now been stored.
The basic ex-works setting can be programmed at any time as an alternative to the individual setting:
Basic setting
(3 seconds = ex-works
programming) Press key 9.
After this (within 3 seconds), press key 5.
The time delay between lowering/raising of the front rotors and
lowering/raising of the rear rotors is set to 3 seconds.