M0032_D
AC-VPRK
Probe Holder
Included:
1
Template for screw locations
1
Clear plastic storage tube
1
Holder for electrical connector with strain relief
1
Rectangle foam pad
1
Rectangle foam pad with cut out
4
E-Z Anchors
2
#8 x 1½” Phillips pan head screws for use with holder
2
#8 x ¾” Phillips flat head screws for use with storage tube
Installation Instructions:
1. Locate area for probe holder.
2. Tape template to wall with the top of template 49” from the floor
3. Press screw driver through the hole locations (3 in total) to mark the wall and then remove
template.
4. Screw EZ anchors into wall through these marks.
5. Place the holder for the electrical connector over holes #1 and #2 and using the 1½” pan head
screws, screw into wall.
6. Remove liner from rectangle foam pad with cutout, align with interior bottom of holder and install.
7. Remove liner from rectangle foam pad and align to the edge of the previously installed foam pad
and install on back side of holder covering screws from step#5.
8. Screw one of the ¾” long flat head screws into hole #3. Do not screw in all the way leave enough
thread to allow storage tube keyhole to be slid over the screw.
9. Adjust the storage tube to be vertical and mark lower screw position #4 through the access hole
in the front of the storage tube. Hole #4 is 11” lower than hole #3.
10. Remove the storage tube and screw EZ Anchor into wall in #4 hole position. Partially screw in ¾”
long screw and mount storage tube through keyhole slots.
11. Tighten screws through access holes.
Do not over tighten.
Tighten to the point that you can still
slide the storage tube up and off for cleaning.
Operation:
1. After disinfection and proper rinsing, dry the probe with paper towel.
2. Place the electrical connector into the holder facing foam pad.
3. Place the probe into the plastic tube while putting the cable behind the strain relief.
