CITYLIFT STACKER 2LHS-6000, Manual

Page: 14 / 17

FOUNDATION DRAWING
© CityLift Parking | www.cityliftparking.com | 844.388.0424
1. Tolerance of levelness must below 5mm, compressive strength of concrete must be above 200kg/cm2.
2. Thickness must be above 300mm and strength grade must be more than 250.
3. Ensure the new concrete be cured by at least 28 days minimum.
4. DO NOT install this lift on any asphalt surface or any surface other than concrete.
5. DO NOT install this lift on expansion seams or on cracked or defective concrete.
6. DO NOT install this lift on a second/elevated floor without first consulting building architect.
7. DO NOT install this lift outdoors unless special consideration has been made to protect the power unit from in climate weather conditions.
8. Leave enough space for the control cabinet.
9. Always use architects plans when available. Check layout dimension against floor plan requirements making sure that adequate space is available.
10. The area where the lift will be located should be free of overhead obstructions such as heaters,building supports, electrical lines etc.
- damage caused by rain, excessive humidity, corrosive environments or other contaminants.
- any change or modification made to the equipment without prior agreement.
These warranties do not extend to any cosmetic defect not interfering with equipment functionality or any incidental, indirect, or consequential loss, damage, or expense that may result from any defect, failure, or
malfunction of a CityLift Parking lift or the breach or delay in performance of the warranty. This warranty is exclusive and in lieu of all other warranties expressed or implied. CityLift Parking makes no warranty on
components and/or accessories furnished to CityLift Parking by third parties. These are warranted only to the extent of the original manufacturer’s warranty to CityLift Parking. Other items not listed but may be
considered general wear parts. CityLift Parking reserves the right to make design changes or add improvements to its product line without incurring any obligation to make such changes on product sold previously.