The SHoW DMX OEM Receiver User’s Manual
Rev 1.1 10/14/08
14 of 27 Pages
Connections
J3 – ICPS Programming port (not normally used by end-user)
J4: DMX
J4 Pin 1:
DMX Common
J4 Pin 2:
DMX –Data
J4 Pin 3:
DMX +Data
J5: +VDC Power Input
J5 Pin 1:
+5 or 9-24 VDC Input
J5 Pin 2:
DC Common
Hardware Configuration
The OEM Receivers are provided with a 6 position SMT DIP Switch S3 (see Figure 5).
S3 positions 1-5 are factory configured and should not be changed.
The OEM Receivers are provided with an onboard DC/DC regulated power supply that
will accept any input voltage from +9VDC to +24VDC and generate the required 5VDC
regulated supply voltage for the Unit.
Set S3-p6 to 5V (Up) for +5VDC power, and set to HV (Down) for 9-24VDC power.
As noted above, this switch must be correctly set to assure proper operation.
Operating the SHoW DMX OEM Receiver
Once installed and provided with appropriate power, the SHoW DMX OEM Receiver
operates basically the same way that a standard SHoW DMX 5610 or 5611 Receiver
works. A SHoW DMX Transmitter receives DMX or RDM data from a source and
broadcasts it via radio waves. The radio signal is picked up by the OEM Receiver and
converted back into wired DMX or RDM data. The OEM Receivers have all of the
SHoW DMX RDM capability, including RDM Responder and RDM Proxy features, and
may be controlled, configured and communicated with via RDM through the SHoW DMX
RDM Monitor.
Since the 5605/5606 OEM Receiver is configurable as a half duplex RDM Responder, it
is capable of transmitting as well as receiving when used in the RDM mode.
The CTI 5605 SHoW DMX OEM Receiver is the North American version and meets all
North American (FCC and IC) radio requirements. The 5605 OEM Receiver’s maximum
broadcast power output is 125mW FCC/395mW ETSI when equipped with the standard
CTI 7” 5dBi Antenna.
The 5606 SHoW DMX OEM Receiver is the international version and meets all North
American and CE radio requirements. The 5606’s maximum broadcast power output is
32mW FCC/100mW ETSI when equipped with the standard CTI 7” 5dBi Antenna. All
other controls and features are the same for both models.
As noted in the compliance section on page 5, OEM Applications of these City Theatrical
Inc. products are not to be considered compliant with agency requirements until the final
