Page 11 of 29
The Setup Wizard
The Setup Wizard will guide you to configure basic setups for Wired DMX control, Internal
Scenes Wireless DMX control, Ethernet control, or Internal Scenes. To use the Setup Wizard,
navigate to the Setup Wizard menu and press ENTER to Start. Continue to press ENTER to
select choices and to move through the Wizard
.
Input Setup>
Sets the input and control protocol to be used. Select DMX512-A, Internal Scenes,
Art-Net, Streaming ACN or SHoW DMX.
Personality>
Sets a fixture personality for all 12 of the CKDMX ports. Select RGB3 16-bit, RGB3
8-bit, iW 8-bit, RGBAW 16-bit, RGBAW 8-bit RGB5 16-bit, or RGB5 8-bit. Note, fixtures are
automatically zapi-ed when PERSONALITY is selected to assure correct configuration
Base Address>
Sets the unit’s base DMX address and addresses the CKDMX ports
sequentially. Select any DMX address from 1 -512
Universe (when Ethernet is selected)
SHoW ID (When SHoW DMX is selected) Sets the SHoW ID (hopping pattern and bandwidth
setting) for use in a SHoW DMX wireless DMX system.
A
Quick Start Setup
Label is provided on the top of the unit:
Figure 5: Quick Start Setup Label
For more advanced and detailed configuration, proceed to the menu for the feature you wish to
configure.
Input Setup
Use this menu to configure the PDS-750 TRX to accept control data from any one of the many
supported control protocol options, and to set the various configuration options for each of the
different protocols supported. This is a dynamic menu range; the options vary with the protocol
selected, so options are only presented when they are pertinent to the selected protocol.
When using one of the Ethernet protocols, the PDS-
750 TRX’s outputs can be assigned to any
supported Universe while the DMX output is assigned to a different supported Universe.
