Page 17 of 31
6550 PDS-375 TRX Manual R6.docxx
•
Are you sure? [working]
Data Hold T-Out:
•
0-Infinite
CK Quiet Mode:
•
On
•
Off
When CK Quiet Mode is ON, the CKDMX outputs are turned off unless level changes occur, so
static DMX levels are not constantly refreshed. This feature is provided for use in installations
where data traffic on the fixture cables must be minimized.
Stand-Alone Routines
The PDS-375 TRX contains eight stand-alone routines, which can be assigned to the six preset
Scenes.
In the stand-alone routines, the PDS-375 TRX outputs the selected routine as a DMX
signal from its 5PXLR wired DMX output port.
You may setup Internal Scenes from the
Setup Wizard
or follow the following procedure to set
up Internal Scenes directly using the
Scene Setup
Menu:
To select Stand-Alone Routines (Not using Setup Wizard):
From the Top Menu, push the Enter Button to access the various Setup Menu choices, use the
Down Button to scroll to
Advanced Setup
and select (Enter Button)
Under Control Method: select
Internal Scenes
Use up/down arrows to navigate to
Port Setup
and select (Enter Button) use the Down Button
to scroll to
Personality
and select (Enter Button)
Under All Personality: select
RGBAW 8-bit
Back up to the Setup Menu and scroll to
Scene Setup
to assign Stand-Alone Routines to
Scenes (1-6) and configure the Routines selected. Set unused Scenes to Disabled.
Make sure your LED fixtures are either RGB only fixtures (TR series) or set for RGBAW 8-bit
(TRX series).
Fixed Color
This show routine holds a single user selectable color. The Color setting is displayed as Red,
Green, Blue, Amber and White (RGBAW) levels in hexadecimal. Press the Enter button to edit
the colors. A blinking cursor will appear under the first character in the R level. Use the Up and
Down button to adjust. Use the Left and Right buttons to move to the other character fields.
You can monitor the level by watching a connected ColorBlast as the output is updated while
you adjust these levels. When you have completed setting the color push Enter to record your
setting.
Cross Fade
This show routine executes a continuous cross fade between two RGB colors. The adjustable
parameters are the fade rate and color selection. To adjust the fade rate, go to the Color Fade
1
These Stand-Alone routines match the built-in Routines provided in the CTI MasterBlast Controller.
