Operation
With VOLUME turned down and power switch off, connect the IEC lead to an appropriate mains outlet.
Connect output of mixer or any line level signal to the INPUT combo connector via 6.3mm jack or XLR.
Alternatively, for ST5, ST6 and ST8 models, an unbalanced line level signal can be connected via RCA connector.
Press the power switch on and gradually increase the VOLUME until the input signal is heard through the speaker.
For ST5, ST6 and ST8 models, the high frequency output from the tweeter can be adjusted using the HF LEVEL ADJUST control
For the ST10S, both left and right signal should be fed first to the sub unit and the THRU outputs then connected to the tops.
For ST10S, the crossover frequency can be adjusted via the FREQUENCY control. INPUT LEVEL adjusts L + R input volume.
A phase button on the rear of the ST10S enables the user to invert the signal if there are low frequency phase problems.
(This can occur when the sub is located at a distance from the other monitors which causes low frequencies to be cancelled out)
Trial and error is usually a good method for checking phase – the best switch position is the one which gives the most sub output.
.
SPECIFICATIONS
ST10S
ST8
ST6
ST5
Power supply
220-240Vac 50/60Hz (IEC)
Main driver
25cm (10”)
20cm (8”)
16.5cm (6.5”)
12.5cm (5”)
HF unit
2.5cm (1”) neodymium silk dome tweeter – ferrofluid-cooled
Connectors
Combo (6.3mm jack or XLR) or RCA
Combo (Jack or XLR)
Output power RMS (LF/HF)
100W
75/15W
50/15W
35/15W
Frequency response
40 - 150Hz
45Hz - 20kHz (±2dB)
50Hz - 20kHz (±2dB)
53Hz - 20kHz (±2dB)
Input impedance
10kΩ
S/N Ratio
82dB/90dB
THD
0.05/0.02%
Dimensions
400 x 400 x 445mm
380 x 265 x 305mm
320 x 225 x 265mm
280 x 190 x 225mm
Weight
14.5kg
9.0kg
7.0kg
5.0kg
Troubleshooting
No output and no LEDs lit
Check POWER switch is on
Check mains lead is connected and fuse hasn’t blown
Power LED lit but no sound output
Check signal leads are OK and connected properly
Check VOLUME or INPUT LEVEL is not turned fully down
Output is low
Check input signal is not very low level
Increase VOLUME or INPUT LEVEL control
Output is loud or distorted
Reduce output level of mixer or audio signal feed
Decrease VOLUME or INPUT LEVEL control
© Citronic 2011
