Citronic MP-X10, Owner'S Manual, Page: 12 / 26

Page 12 of 26
8. LINE/PHONO SELECTOR SWITCH – These switches are used to change the voltage
line levels of there respected LINE/PHONO RCA inputs jacks. When connecting turntables
that do not have a built-in pre-amp to these jacks be sure the corresponding switch is in
the PHONO” position, and when using line level input devices be sure the switch is in the
LINE position.
NOTE: Always be sure main power is shut off before changing the position
of the Line Level Selector Switch.
9. CHANNEL LINE/PHONO INPUT CONNECTORS – Connect turntables without a built-in
pre-amp to the PHONO input and other devices such as. CD players, Tape Decks, MP3
devices and other line level instruments must be connected to the LINE input. Ensure
that you switch the LINE/PHONO switch to select the input. The input level volume is
controlled by the channel GAIN control.
10. GND (GROUND TERMINAL) – Be sure to connect turntable ground leads to either or
both of the two available ground terminals. This will reduce the humming and popping
noises associated with magnetic phono cartridges.
11. MICROPHONE 2 JACK – This combo jack will accept a standard 6.3mm jack plug or
XLR 3-pin balanced male plug. The volume output level for microphone will be controlled
by its own respective VOLUME control on the front panel.
General Functions and Controls – Rear Panel
1. PLAY INDICATOR - The play indicator will glow when the unit is in play mode.
2. RELOOP INDICATOR - Appears when LOOP is engaged or ready to be engaged.
3. SINGLE INDICATOR - This indicates that the track is in single play mode, the track will
play once and return to CUE mode. If the single indicator is not on, the unit is in
continuous mode.
4. FILE TYPE – Indicates if the music file is MP3, WAV or AAC
5. TRACK DISPLAY - This indicator describes which track is currently cued or is playing.
6. REMAIN / ELAPSED INDICATOR - When REMAIN is indicated in the VFD display the
TIME METER will show the current track's remaining time. When ELAPSED is indicated in
the VFD display the TIME METER will show the current track's elapsed time.