Monolith-500 User Manual
Rear Panel
Setting up
Insert the threaded end of the telescopic speaker pole into the socket at the top of
the subwoofer unit and turn clockwise until fully tightened in place.
Adjust the pole to the required height, locking in place with the attached pin.
Mount the column speaker onto the 35mmØ pole and face towards the listeners.
Connect the satellite speaker output (6) to the column speaker using the supplied SPK lead.
Connect a line level (0dB = 0.775Vrms) input to the balanced XLR input (1) or alternatively to
the unbalanced RCA sockets (3) or 3.5mm stereo jack (4)
If further Monolith-500 sets or other active speakers are to be connected to the same signal,
use an XLR lead from the XLR line output (2)
The subwoofer crossover frequency will determine the point at which the subwoofer rejects
mid and treble frequencies and can be voiced to suit the program material.
Normally, this should be set between 70Hz and 120Hz and is a matter of personal preference.
Connect the Monolith-500 subwoofer unit to the mains using the mains IEC lead supplied (13)
1.
XLR line input
2.
XLR line output (through)
3.
RCA L+R (summed) line input
4.
3.5mm stereo jack (summed) line input
5.
Cooling fan vent (do not cover)
6.
Satellite speaker output (to column)
7.
Full range output level
8.
Subwoofer crossover frequency
9.
Subwoofer output level
10. Subwoofer clip indicator
11. Full range clip indicator
12. Power on indicator
13. IEC mains inlet & fuse holder
14. Power on/off switch
