™
Each main input channel has a gain control offering <-70 to +10dB gain range allowing
compensation for differing input levels.
11. Channel Effect Select Button
The button activates the effects (21) on to the selected channel.
12. Cue Select Button
This button allows pre-fade listen on input signals of any of the 4 music channels through the
headphones
13. Channel EQ Controls
Each music channel has a 3-band EQ stage providing comprehensive control over individual input
EQ content.
EQ Control ‘Lo’
This control allows 10dB of boost and -30dB of cut to the low frequencies.
EQ Control ‘Mid’
This control allows 10dB of boost and -30dB of cut to the mid frequencies.
EQ Control ‘Hi’
This control allows 10dB of boost and -30dB of cut to the high frequencies.
14. 45mm Channel Fader
This slider sets the signal level of the channel being mixed on to the main output or sent to the
fully assignable crossfade.
15. Removable Crossfader
This dipless 45mm rail-glide crossfader is fully assignable to any of the four main music channels
set by the assign select switches (16).
16. Crossfader Assign Switches
Any of the four music channels can be assigned to either side of the crossfader by the setting of
these switches.
17. Headphone Input
Standard 6.3mm (1/4”) jack input.
18. Headphone Pan Control
This slider allows either the selected cued channel to be listened to through the headphones, the
master output or a mix of both. This allows for music to be mixed in the headphones prior to
sending to the output.
19. Headphone Level Control
Sets desired volume level to the headphones. The headphone program depends on the position of
the headphone panel control (18) and the cue buttons (12).
20. LED Monitor
Twin 10 segment LED ladders shows the signal of the master output.
21. Effect level control
These control the amount of effect that is added to the selected channel. To add the effects to a
channel press the EFF (11) (3 & 6) buttons.
22. Video Switcher
This function allows for 2 video inputs to be switched to 2 video outputs (31). When the button is
OUT the video input 1 will be sent to the 2 outputs, when button is IN the video input 2 will be sent
to the 2 outputs.
23. Master Level Control
This controls the level sent to the Balanced XLR (28) and unbalanced RCA (29) master outputs.
24. Booth Level Control
This controls the level sent to the unbalanced Booth output (30).
25. Volt BNC Light Connector
A 12VDC, 5-Watt output is supplied for connection of a gooseneck lamp.
26. Power On
Controls the AC power to the mixer.
Note: Be sure to switch on the power to your mixer before switching on the amplification system.
