-11-
(3) Adjust the peel sensor.
1
Remove the label backing on the
paper sheet (mounting board) pulled
out, and pass the mounting board
through the peeler unit.
2
Close the peeler unit.
3
First, the peel sensor knob will need to
be turned all the way to the minimum
setting. Using a screwdriver, turn
the knob counter-clockwise all the
way around until it can be turned no
farther.
4
With the label ejected from the printer facing up and raised so that it is 10 mm
from the sensor, turn the knob clockwise little by little. Continue adjusting the
position of the knob to the point where the LED turns on.
3
4
10mm
LED
4
