Citizen CT-D150, Command Reference Manual

Page: 147 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 146 -
2.2.8 Paper Detecting Commands
ESC c 3 n
[Function] Selecting the Paper Sensor valid for a Paper-end signal output
[Code] <1B>H<63>H<33>H<n>
[Range] 0
≤n≤255
[Outline] [The specification which is common to the model]
• This command selects by which Paper Sensor a Paper-end signal should be output. Each bit for “n” has the
following meaning:
Bit Position
Value
0 1
0
Paper Near-end Disabled Enabled
1
Paper Near-end Disabled Enabled
2
Paper-end Disabled Enabled
3
Paper-end Disabled Enabled
4
Undefined — —
5
Undefined — —
6
Undefined — —
7
Undefined — —
[Caution] [The specification which is common to the model]
• This command is valid only for the parallel interface.
[Default] [The specification which depend on the model]
CT-S280 / CT-S281 / CT-S300 / CT-S310 / CT-S2000 / CT-S4000
n=15
CT-P29x series / CT-S301II / CT-D150 / CT-E351
n=15 (no signal at paper near end due to no paper near end sensor.)
CT-S801(II) / CT-S851(II) / CT-S601(II) / CT-S651(II) / CT-S251 / CT-D151 / CT-E651
• MSW3-2 OFF: n=15
• MSW3-2 ON : n=12