— 67 —
GS V m ......... (1)
GS V m n ..... (2)
[Function]
Cutting the paper
[Code]
(1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range]
(1) 0
m
1, 48
n
49
(2) 65
m
66, 0
n
255
[Outline]
Performs the specified paper cutting.
m
Function
0,48
Full cut
1,49
Partial cut (Leaving a bridge area uncut)
65
Paper feed by “cut po {n
×
basic calculation
pitch}”and full cut
66
Paper feed by “cut po {n
×
basic calculation
pitch}”and partial cut (Leaving a bridge area uncut)
[Caution]
• In STANDARD MODE, this command only works when it is
entered at the beginning of a line.
For (1):
• A partial cut (Leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠
0, the paper is fed by “n
×
basic calculation pitch” inches
past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic
calculation pitch (y).
A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.
