4
3. Description of the HazeMax
TM
The HazeMax
TM
w/DMX is CITC’s latest hazing system. No other comparable machine
delivers a thicker, whiter output of 30,000 cfm of digitally controlled haze. New and
improved, the HazeMax
TM
can produce longer on high than the stiffest competition.
Accurate temp control makes shut down history. It now has a quieter pump with a 1500
watt heating head, a 1-channel DMX on board, remote control cycle-timer and hanging
bracket. Best bet for professional haze. Uses water-based CITC hazing fluid. The extra
dry haze leaves no mess, no residue and can be fully controlled with DMX (included).
The following sequence produces haze:
a) The haze generator is preheated for 4 – 8 minutes.
b) The pump is controlled from 0 – 100% output by the Remote
Cycle-Timer Controller or by DMX.
c) The preferred setting is at 50% for best even haze.
NOTE:
At 100% output (3 o’clock on Volume Control or 80% on DMX control) the unit
will produce heavy haze continuously without delay. Pulsating may be observed at
high output. This is normal.
At highest output or Blast, the unit will produce a heavy haze for up to 30
minutes without delays. After 10 minutes haze generator is again warmed up and
again ready to produce haze. Again, pulsating output may be observed.
4.
Safety Instructions
WARNING: Read and understand all labels and operating instructions
before attempting installation.
o
Never open the machine without disconnecting power lead first!
Risk of electrical shock-
This device is supplied with a grounding conductor. To reduce
risk of electrical shock, connect only to properly grounded, grounding type receptacles.
Never remove the third prong from the plug.
o
This machine requires a well-grounded 120 VAC circuit for operation. The HazeMax
TM
draws approximately 15 amps at 120 VAC (8 amps for the 230VAC model). During
HazeMax
TM
operation this circuit should be dedicated to the HazeMax
TM
. If you have any
doubts about the capacity or grounding of your existing circuits, consult a qualified
electrician.
o
Be sure area around hazer is dry before applying electrical power.
o
Make sure that your unit is pointed in a direction that leaves a 10ft (3m) open area out in
front. Place the front of the machine away from direct contact with electrical instruments
and people. Close output is very hot and wet.
o
Never operate the pump without fluid passing through the tube. This could cause the
pump to overheat and damage the piston. Operating the pump without fluid is not
covered under warranty.
o
Fluid is very slippery when spilled. Care in keeping any drips or spills cleaned up is
necessary.
o
Do not store HazeMax
TM
in freezing conditions.
