Page 7
Page 7
Page 7
Page 7
Page 7
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
1.
Locate the Conveyor control.
2.
Route the connection cable (C2102, supplied with control) between
the Conveyor control
and the electrical box near the drive on the
conveyor. The end with the large connector
mounts to the con-
veyor control.
3.
Remove the bottom from the conveyor control and install the connec-
tor into the socket on
the processor board. Tighten the screws
on the plug that attaches it to the socket to
prevent it
from coming loose. Install the cable bushing into the slot at the rear
of the
control enclosure and tighten. Reattach the bot-
tom of the conveyor control and tighten
the screws.
4.
On the Conveyor end of the cable, connect the leads in the large
bundle of 12 wires to the
appropriate wires/terminals in the elec-
trical box per the wiring diagram. The small
bundle of 4
wires is connected to the digital encoder (attached to the drive shaft)
by the
small nylon plug. Be sure to properly orient it (match
the numbers on the plug to the
numbers on the encoder).
5.
Connect power to the conveyor. Go through the SET-UP procedures to
input the conveyor
parameters into the memory of the conveyor
control.
6.
The conveyor control is now ready for operation.
SETTING CONTROL MODE SWITCH
SETTING CONTROL MODE SWITCH
SETTING CONTROL MODE SWITCH
SETTING CONTROL MODE SWITCH
SETTING CONTROL MODE SWITCH
This switch should be in the AUTOMATIC position for normal opera-
tion. In this position, the hand/foot switches will work only when the
conveyor control is ON. This is to prevent the control from losing its
current position. If the conveyor is run with the control turned OFF,
the current position will have to be reset. This cannot happen if the
switch is in the AUTOMATIC position.
Should the conveyor control have to be removed from the conveyor,
move the switch to the MANUAL position to allow the hand/foot switches
to work with the control disconnected.
