Page 30
Troubleshooting Chart
Troubleshooting Chart
TROUBLE
CAUSE
REMEDY
Clean burner holes; blow out dirt.
Adjust per rating plate specification.
Check with factory for correct orifices.
Clean exhaust of lint or restrictions.
Check with factory for correct orifice size. Replace
if needed.
Clean air ducts.
Clean air make-up restrictions.
Clean burners and remove lint.
Check with factory for correct size, replace if
needed.
Check air flow installation per instructions in the
Instruction Manual.
Clean dryer of lint.
Must fully open or replace.
Adjust per rating plate specification.
Clean exhaust system; check installation instructions
for duct size recommendations.
Replace thermostat.
Replace timer.
Check timer; replace if defective.
Main burners
burning improperly.
Low or high gas flame.
Dryer too hot.
Dryer doesn’t stop
properly.
Basket does not reverse.
Burner holes clogged.
Gas pressure too high.
Orifice too large.
Restricted or blocked exhaust.
Incorrect burner orifices.
Inadequate air flow.
Incorrect burner orifices.
Inadequate make-up air flow.
Lint accumulation.
Exhaust duct damper.
Gas pressure too high.
Exhaust system restricted or inad-
equate sized ductwork.
Thermostat defective.
Timer defective.
Reversing timer.
