Cissell HD190, Owner'S Manual

Page: 36 / 74

Page 36
TROUBLE CAUSE REMEDY
Check fuses on circuit breakers. Make sure main
control switch is ON.
Check power source: voltage, phase, and frequency
must be the same as specified on electrical rating
plate.
Turn timer clockwise to desired time setting.
Check wire connections in electrical box on rear of
dryer.
Check coils and contacts.
Check voltage at motor teminals. Voltage must be
within (plus or minus) 10% of voltage shown on
motor rating plate -- if not, check with local power
company for recommended corrective measures.
Check with local power company to insure that
wiring is adequately sized for load.
Check all electrical connections and tighten any
loose connections.
Check installation sheet in service section of this
manual for recommended make-up air openings.
Clean lint accumulation on and around motors.
Motors should not be covered with or filled with
lint.
Close door.
Adjust switch by removing cover and bend actuator
lever to clear switch button 3/8” with cover in
place.
Check continuity across switch with power off, in
closed and open switch. If no
continuity, replace switch.
Push in contactor trip button. If motor starts, check
voltage going to pull-in solenoid. If present,
replace contactor. If not, problem is before motor
contactor.
Adjust timer (see Maintenance Section).
Check timer to see if it is working.
No power.
Incorrect power.
Time off.
Loose wiring connections.
Defective starting relay.
Low voltage.
Inadequate wiring.
Loose connections.
Inadequate air.
Poor housekeeping.
Loading door open.
Door switch out of adjustment.
Defective door switch
Defective basket motor contactor.
Reversing timer.
Motor will not start.
Motor tripping on
thermal overload.
Basket motor will not
run.
Basket will not reverse.
Troubleshooting Chart