6 Gigabit Interface Converter Installation Note
Removing a GBIC
Figure 2
Installing a GBIC
Step 4
Slide the GBIC through the flap covering the opening into the slot until you hear a click.
The click indicates the GBIC is locked into the slot.
Warning
Class 1 laser product
Warning
Invisible laser radiation may be emitted from the aperture ports of the single-mode fiber-optic
modules when no cable is connected. Avoid exposure and do not stare into open apertures.
Step 5
When you are ready to attach the network interface fiber-optic cable, remove the plug
from the GBIC and save the plug for future use.
Removing a GBIC
If you are removing a defective GBIC, perform these steps.
Step 1
Disconnect the network fiber cable from the GBIC SC connector.
Step 2
Release the GBIC from the slot by simultaneously squeezing the two plastic tabs (one on
each side of the GBIC).
Step 3
Slide the GBIC out of the Gigabit Ethernet module slot. A flap drops down to protect the
Gigabit Ethernet module connector.
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
3 PORT GIGABIT ETHERNET SWITCHING MODULE
STATUS
WS-X5403
LINK
LINK
LINK
11826
Plug