Cisco Webex 800 Series, User Manual

Page: 15 / 130

Don’t use the Android Battery Saver mode. It curtails functionality to conserve battery life. In Battery
Saver mode, features that you rely on may not work. If you require more than one charge per shift, contact
your system administrator for a second battery.
For your Cisco Webex Wireless Phone 860 and 860S, you can use the hot swap battery change technique to
maintain connectivity without loss of functionality.
The Cisco Webex Wireless Phone 840 and 840S do not have an internal battery, so they do not support the
hot swap feature.
Note
Related Topics
Phone Setup , on page 31
Make an Emergency Call from a Locked Screen , on page 43
Battery Hot Swap for 860 Phones , on page 34
Turn On Your Phone
Generally, your system administrator deploys your phone with multiple other phones and configures the phone
parameters before you receive the phone. In this case, the phone registers with the system and is ready for
you to use when you turn it on. If your phone doesn’t work when you turn it on, contact your system
administrator.
After you power on your phone, allow the screens to cycle through a bootup screen, the Cisco splash screen,
and the Android screen. If your organization requires a PIN or passcode, the lock screen displays.
Before you begin
To maximize the storage capacity and lifespan of the battery, fully charge the battery before the first use of
the phone.
To check the battery status while the phone is plugged into the charger, briefly press the Power button. When
the battery life indicator is solid, the battery charge is full.
Note
Procedure
Press and hold the Power button until the phone vibrates and the first screen displays.
Related Topics
Phone Battery Charging , on page 36
Hardware and Buttons , on page 7
Cisco Webex Wireless Phone 800 Series User Guide
5
Your Phone
Turn On Your Phone