Cisco WAP300N, User Manual

Page: 135 / 660

12
Setting Up: Basics
Linksys WAP300N
RADIUS
RADIUS Server Enter the IP address of the RADIUS server
RADIUS Port
Enter the port number of the RADIUS
server The default is
1812
Shared Key
Enter the key shared between the router
and the server
Encryption
Select a level of WEP encryption, 40/64-
bit (10 hex digits) or 104/128-bit (26 hex
digits)
Key 2
Enter the WEP key of your network Key
2 is the transmit key used by this device
3. After you have entered all required information, click Save Settings
How to use Wireless Media Connector
mode
In addition to the topics below, see the topic “How to set up QoS (Quality of
Service)” on page 20
How to select Wireless Media Connector mode
To select Wireless Media Connector mode:
Setup > Operation Mode
1.
Log into the browser-based utility (see “How to open the browser-based
utility” on page 8)
2.
Click the
Setup
tab, then click the
Operation Mode
page
3.
Select
Wireless Media Connector
, then click
Save Settings
We recommend using wireless network site survey to set up your
WAP300N in Wireless Media Connector mode Wireless network site
survey identifies wireless networks with in the range of your WAP300N,
so that you can easily select one of them to connect to For instructions,
see How to run a wireless network site survey below
How to run a wireless network site survey
We recommend using wireless network site survey to set up your WAP300N
in Wireless Media Connector mode Wireless network site survey identifies
wireless networks within range of your WAP300N, so that you can easily select
one of them to connect to
To run a wireless network site survey:
1.
Log into the browser-based utility (see “How to open the browser-based
utility” on page 8)
2. Click the Wireless tab, then click the Wireless Network Site Survey
page The site survey runs and displays the following information: