Configuring the WAP2000 Access Point
Setting Up Your Access Point
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide
19
6
Configuring Basic Setup Settings
To configure the basic setup settings of the access point, follow these steps:
STEP 1
Click
Setup > Basic Setup
.
STEP 2
In the Basic Setup section, configure the following settings:
•
Host Name
—Enter the host name of the access point.
You can use the host name to access the web-based configuration utility
through the network if a record of the host name exists in your DNS server.
The access point publishes the host name to your DNS server if you
configured the access point to acquire the IP address from a DHCP server.
Follow your organization’s policy when assigning this name. The default
name is
Cisco
.
•
Device Name
—Enter the device name for the access point.
This name is only for identification purposes. Unique, memorable names are
helpful, especially if you are employing multiple access points on the same
network. This name helps you identify the access point after you log in.
•
Contact
—Specify the contact string for your SNMP agent.
•
Location—Specify the location string for your SNMP agent.
The default name is
WAP2000
.
STEP 3
Click
Save
.
