Cisco UCS C240 M4, Installation And Service Manual

Page: 60 / 190

3-18
Cisco UCS C240 M4 Server Installation and Service Guide
OL-32474-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Replacing SAS/SATA Drives
Tip
You do not have to shut down or power off the server to replace SAS/SATA hard drives or solid state
drives (SSDs) because they are hot-swappable. To replace an NVMe PCIe SSD drive, which must be shut
down before removal, see
Replacing NVMe PCIe Solid State Drives, page 3-19 .
Step 1 Remove the drive that you are replacing or remove a blank drive tray from an empty bay:
a. Press the release button on the face of the drive tray. See Figure 3-10 .
b. Grasp and open the ejector lever and then pull the drive tray out of the slot.
c. If you are replacing an existing drive, remove the four drive-tray screws that secure the drive to the
tray and then lift the drive out of the tray.
Step 2 Install a new drive:
a.
Place a new drive in the empty drive tray and replace the four drive-tray screws.
b. With the ejector lever on the drive tray open, insert the drive tray into the empty drive bay.
c.
Push the tray into the slot until it touches the backplane, and then close the ejector lever to lock the
drive in place.
Figure 3-10 Replacing Drives
1 Release button 3 Drive tray securing screws (four)
2 Ejector lever –
352958
H
D
D02
H
D
D03
HDD
04
H
D
D05
H
D
D06
H
D
D07
HDD
08
HDD
09
HDD
1
0
HDD
11
HDD
1
2
HDD
1
3
HDD
1
4
HDD
1
5
HDD
1
6
HDD
1
7
HDD
1
8
HDD
1
9
HDD
20
H
D
D21
HDD
22
HDD
23
H
D
D24
3
3
3
3
2 1