Figure 9: Inner-Rail Release Clip
Outer slide rail attached to rack post
3
Inner-rail release clip
1
-
Inner rail attached to appliance and inserted
into outer slide rail
2
Step 5
(Optional) Secure the appliance in the rack by using the two screws that are provided with the slide rails. Perform this
step if you plan to move the rack with appliance installed.
With the appliance fully pushed into the slide rails, open a hinged slam latch lever on the front of the appliance and insert
a screw through the hole that is under the lever. The screw threads into the static part of the rail on the rack post and
prevents the server from being pulled out. Repeat for the opposite slam latch.
Installing the Cable Management Arm (Optional)
The cable management arm (CMA) is reversible left-to-right. To reverse the CMA, see
Management Arm (Optional), on page 20
before installation.
Note
Step 1
With the appliance pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the appliance onto
the end of the stationary slide rail that is attached to the rack post. Slide the tab over the end of the rail until it clicks and
locks.
Cisco Secure Network Server 3600 Series Appliance Hardware Installation Guide
19
Installing the Appliance
Installing the Cable Management Arm (Optional)
