8-5
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
Chapter 8 Troubleshooting
Troubleshooting Overview
SCE 2000 Operational Status
lists the operational states of the SCE 2000. The Status LED on the SCE 2000 Front Panel
reflects the current SCE 2000 operational status. The operational status can be displayed using CLI
command
show system operation-status
.
Table 8-2
SCE 2000 Operational States
SCE 2000
Operational Status Description
Status LED
State
Booting
Initial state after reset
Orange
Operational
SCE 2000 becomes operational after completing the following
process:
•
Boot is completed
•
Power self-tests are completed without failure
•
Platform configuration is applied
Flashing green
Warning
SCE 2000 is fully operational (as above) but one of the following
occurred:
•
Line ports (GBE ports) to the link are down
•
Management port link is down
•
Temperature raised above threshold
•
Voltage not in required range
•
Fans problem
•
Power supply problem
•
Insufficient space on the disk
Note
Warning Note: If the condition that caused the SCE 2000
to be in Warning state is resolved (for example, link is up)
the SCE 2000 reverts to Operational state. Flashing
orange
Flashing
orange
Failure
System is in Failure state after Boot due to one of the following
conditions:
•
Power on test failure
•
Three abnormal reboots in less than 20 minutes
•
Platform configured to enter Failure mode consequent to
failure-induced reboot (this is configurable using CLI
command)
Note
Depending on the cause of failure, the management
interface and the platform configuration may or may not
be active/available. Red
Red
