The following figure shows the rear panel of the WSA S695. See
for a description
of the LEDs.
Figure 11: S695 Rear Panel
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
You can connect P1 and P2 to an L4
switch, WCCP router, or network
switch.
Note
2
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
1
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
4
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
3
1050-W AC power supply (PSU 2)
6
1050-W AC power supply (PSU 1)
5
USB 3.0 Type A (USB 1)
8
Threaded holes for dual-hole grounding lug
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
7
Management interface 1 (MGMT 1)
Restricted to management use only
10
USB 3.0 Type A (USB 2)
9
RPC port (RPC)
Use for remote power cycling.
12
Management interface 2 (MGMT 2)
Not in use
11
Unit identification button
14
Serial console port (Console)
RJ-45 connector that directly connects a
management computer to the appliance.
13
Overview
12
Overview
Rear Panel
