Cisco RFGW-10, Hardware Installation Manual

Page: 33 / 182

1-19
Cisco RF Gateway 10 Hardware Installation Guide
OL-16264-04
Chapter 1 Overview
Cisco RFGW-10 Components
Front Panel LED
CONSOLE port This is a 10/100/1000 port that uses an RJ-45 connector. The console port allows you
access the switch either locally (with a console terminal) has an RJ-45 connector. The
console port allows you to perform the following functions:
•
Configure the switch from the CLI
•
Monitor network statistics and errors
•
Configure SNMP agent parameters
10/100/1000 MGT port The Ethernet management port is a Layer 3 host port to which you can connect a PC.
You can use the Ethernet management port instead of the console port for network man-
agement.
Note
When connecting a PC to the Ethernet management port, you must assign an IP
address.
LINK LED The 10/100/1000 MGT port has a link LED associated with it. See Table 1-9 .
1G/10G UPLINKS
(SFP/SFP+) ports The Supervisor Engine 7-E has four 1-G or 10-G ports that use either SFP transceivers
or SFP+ transceivers.
Uplink port LEDs Each of the four uplink ports has two LEDs associated with it. One LED displays port
status when a 1-GB SFP transceiver is installed in the port socket. The second LED
displays uplink port status when a 10-GB SFP+ transceiver is installed in the port socket.
See
Table 1-9 .
Table 1-9 Cisco RFGW-10 Supervisor Engine 7-E Front Panel LEDs
LED Color and Meaning
STATUS The STATUS LED indicates the status of he supervisor engine.
•
Green—All diagnostic tests have passed
•
Orange—System boot or a diagnostic test is in progress.
•
Red—A diagnostic test failed.
•
Off—The supervisor engine is disabled or is not powered up.
ACTIVE SUP Indicates whether the supervisor engine is active or standby.
•
Green—Supervisor engine is active (in redundant supervisor engine
configurations)
•
Off—Supervisor engine is in standby mode (in redundant supervisor
engine configurations)
UTILIZATION When the switch is operational, the eight utilization LEDs indicate the current
traffic load over the backplane as an approximate percentage value. Each LED
lit green indicates approximately 12.5 percent of load.
Feature Description