6-12
Cisco RF Gateway 10 Hardware Installation Guide
OL-16264-04
Chapter 6 Cabling the Cisco RFGW-10 UEQAM
Installing or Replacing the Cables in the UCH2
Figure 6-10
Using a Screwdriver to Slide Open the Lock Bar on the UCH2
Step 3
Remove the ESD cap from a cable (see
) and place it in the hole in the
UCH2. (See
.) Use
to determine the correct color and location for each colored
cable.
Figure 6-11
Removing an ESD Cap from an MCX Connector
Figure 6-12
Removing an ESD Cap from an F Connector
Step 4
Insert and wiggle the connector into the hole.
155820
155824
155825
