![background image](http://html.mh-extra.com/html/cisco/rf-gateway-1-modules/rf-gateway-1-modules_configuration-manual_64976227.webp)
Authentication
78-4025112-01 Rev H0
203
Authentication
Password-based authentication is available for RF Gateway 1 users operating
software release 06.1.x. This chapter describes how to configure user authentication
capabilities. The unit can be operated without authentication enabled (default
factory setting) or enabled in two user-settable (Local and Remote) modes of
operation.
Authentication Configuration
The RF Gateway 1 is shipped to customers with the authentication default factory
setting set to disabled as shown in the following screen. A unit in this state allows
the user full read and write access to all configurable parameters. The RF Gateway 1
web management page appears with the login tab grey and un-selectable. Local and
remote authentication modes are available. To enable Local Authentication, refer to
To Set up Local Authentication
(on page 203). To enable Remote Authentication,
refer to
To Setup Remote Authentication
(on page 207). Once the authentication
mode is enabled, the user must provide a password to make any new authentication
mode changes. While operating in either mode, the RF Gateway 1 management
interface allow users alphanumeric passwords of 4 to 16 characters in length.
Local Authentication
The RF Gateway 1 supports five read only users (rfgw1, rfgw2, rfgw3, rfgw4, rfgw5,
and one read-write user (admin). All these users have the default password (factory
setting) "0000". Additional login ids cannot be provisioned in Local mode. Refer to
To Change Default Password
(on page 205).
To Set up Local Authentication
1
Navigate to the
System/Authentication page.
Result:
The following page is displayed.
2
In the
Mode
drop-down window, select
Local
as the mode of operation.
The default timeout value is 30 minutes. The timeout value can be changed, if
required.
3
Click
Apply
.
Summary of Contents for RF Gateway 1 Modules
