7-8
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 7 PIX 535
Installing Failover
Installing Failover
To set up a failover connection, perform the following steps:
Step 1
Power off both the primary and secondary units.
Note
Both chassis must be the same model number, have at least as much RAM, have the same Flash
memory size, and be running the same software version. Note that the PIX-4FE and PIX-4FE-66
cards are considered equivalent and interchangeable. You can install a PIX-4FE in the primary
unit and a PIX-4FE-66 in the secondary unit, as long as you install them in the same slot number
of each chassis. For example, if you install a PIX-4FE in Slot 1 of the primary unit, you must
also install the PIX-4FE-66 in Slot 1 of the secondary unit.
Step 2
Locate the failover cable (shown in
). This cable is shipped separately from the PIX security
appliance. The cable is labeled “Primary” on one end and “Secondary” on the other.
Install the cable for the PIX 535 as shown in
.
Figure 7-5
PIX 535 Failover Cable Connection
Step 3
Connect the Primary end of the failover cable to the first PIX security appliance, that is, the one you have
already configured.
Step 4
Connect the Secondary end of the failover cable to the standby unit.
Step 5
Connect a power cord to the power connector on the rear panel of each unit, and the other end of each
power cord to (preferably separate) power outlets.
Step 6
If you are using Stateful Failover, use one of the following types of connections, that is appropriate for
your system, between the dedicated interfaces on the PIX security appliance:
•
Category 5 crossover cable directly connecting the primary unit to the secondary unit
•
100BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch
•
1000BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch
Note
For Stateful Failover on the PIX 535, you must use a Gigabit Ethernet (GE) failover link with
GE interfaces.
F
A
I
L
O
V
E
R
F
A
I
L
O
V
E
R
12395
SECON
DARY
PR
IM
AR
Y
Primary end
Secondary end
