Cisco ONS 15600 Series, Reference Manual, Page: 226 / 340

11-6
Cisco ONS 15600 Reference Manual, R7.0
Chapter 11 Alarm Monitoring and Management
11.2.4 Conditions Window Actions
11.2.4 Conditions Window Actions
Table 11-5 shows the actions you can perform in the Conditions window.
The current set of all existing conditions maintained by the alarm manager appears when you click the
Retrieve button. The set of conditions retrieved is relative to the view. For example, if you click the
button in the node view, node-specific conditions appear (
Figure 11-3 ). If you click the Retrieve button
in the network view, all conditions for the network (including ONS 15600 nodes and other connected
nodes such as ONS 15454s) appear, and the card view shows only card-specific conditions.
Figure 11-3 Viewing Conditions in the Conditions Window
Table 11-5 Conditions Display
Button Action
Retrieve Retrieves the current set of all existing fault conditions, as maintained by
the alarm manager, from the ONS 15600.
Filter Allows you to change the Conditions window display to only show the
conditions that meet a certain severity level or occur in a specified time. For
example, you can set the filter so that only Critical conditions display on
the window.
There is a Filter icon button in the lower-right corner of the window that
allows you to enable or disable the filter feature.