Cisco ONS 15600 Series, Reference Manual, Page: 212 / 340

9-56
Cisco ONS 15600 Reference Manual, R7.0
Chapter 9 Management Network Connectivity
9.7.10 OSI Provisioning in CTC
9.7.10 OSI Provisioning in CTC
Table 9-16 shows the OSI actions that are performed from the node view Provisioning tab. Refer to the
Cisco ONS 15600 Procedures Guide for OSI procedures and tasks.
Table 9-17 shows the OSI actions that are performed from the node view Maintenance tab.
Table 9-16 OSI Actions from the CTC Provisioning Tab
Tab Actions
OSI > Main Setup • View and edit Primary Area Address.
•
Change OSI routing mode.
•
Change LSP buffers.
OSI > TARP > Config Configure the TARP parameters:
•
PDU L1/L2 propagation and origination.
• TARP data cache and loop detection buffer.
•
LAN storm suppression.
• Type 4 PDU on startup.
•
TARP timers: LDB, T1, T2, T3, T4.
OSI > TARP > Static TDC Add and delete static TARP data cache entries.
OSI > TARP > MAT Add and delete static manual area table entries.
OSI > Routers > Setup
•
Enable and disable routers.
•
Add, delete, and edit manual area addresses.
OSI > Routers > Subnets Edit SDCC, LDCC, and LAN subnets that are provisioned for OSI.
OSI > Tunnels Add, delete, and edit Cisco and IP-over-CLNS tunnels.
Comm Channels > SDCC
•
Add OSI configuration to an SDCC.
• Choose the data link layer protocol, PPP or LAP-D.
Comm Channels > LDCC
•
Add OSI configuration to an SDCC.
Table 9-17 OSI Actions from the CTC Maintenance Tab
Tab Actions
OSI > ISIS RIB View the IS-IS routing table.
OSI > ESIS RIB View ESs that are attached to ISs.
OSI > TDC
•
View the TARP data cache and identify static and dynamic entries.
•
Perform TID to NSAP resolutions.
• Flush the TDC.