Cisco ONS 15454, Procedure Manual, Page: 162 / 175

1-74
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
78-19286-01
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Required Tools and Equipment (ETSI)
Step 4 Line up the first Y-cable module that you want to install with the desired slot, pull the latch at the bottom
of the Y-cable module to enable the Y-cable module to slide onto the guides, and slide the module down
until it is fully installed in the slot.
Figure 1-31 shows the Y-cable module that can be installed in the
Y-cable module tray.
Figure 1-31 Y-Cable Module
Step 5 Repeat Steps 1 through 4 as necessary for each Y-cable module you want to install.
Step 6
Return to your originating procedure (NTP).
NTP-G15 Install the Common Control Cards
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Purpose This procedure describes how to install the common control cards.
Tools/Equipment Redundant TCC2/TCC2P/TCC3 cards on Cisco ONS 15454 shelf
(required)
AIC-I card (optional)
MS-ISC-100T (optional; for multishelf node configurations)
Prerequisite Procedures NTP-G7 Install the Power and Ground, page 1-33
NTP-G14 Install DWDM Equipment, page 1-66
Required/As Needed Required
Onsite/Remote Onsite
Security Level Provisioning or higher
151959
Tab