Cisco ONS 15454 Series, Procedure Manual

Page: 248 / 850

6-80
Cisco ONS 15454 Procedure Guide, R5.0
August 2005
Chapter 6 Create Circuits and VT Tunnels
NTP-A241 Provision G-Series Ports for Transponder Mode (Tx Mode)
Figure 6-15 One-Port Bidirectional Transponder Mode
Step 6 To provision two-port unidirectional transponder mode ( Figure 6-16 ):
Note In Step 6 , “Port A” represents the first port in a pair and “Port B” the second port in the pair. You
can pair any two ports on a G-Series card in two-port unidirectional mode.
a.
Click the Port A row (for example, Port 1).
b.
Uncheck Auto Negotiation. Ports cannot be provisioned in unidirectional transponder mode when
autonegotiation is enabled.
c. In the TXP Port column, choose Port B (for example, Port 2) from the drop-down list.
d.
In the TXP Mode column, choose RX Only from the drop-down list. CTC completes the Port B TXP
Port with Port A and TXP Mode with TX Only.
e. Click the Port B row and uncheck Auto Negotiation.
f.
Click Apply .
The ports on the CTC card level view display arrows and a line between the back of the ports.