Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 813 / 1218

16-69
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
April 2006
Chapter 16 Card Reference
16.7.3 AD-4C-xx.x Card
16.7.3.2 Power Monitoring
Physical photodiodes P1 through P10, and virtual photodiodes V1 and V2 monitor the power for the
AD-4C-xx.x card. The returned power level values are calibrated to the ports as shown in
Table 16-42 .
16.7.3.3 AD-4C-xx.x Card-Level Indicators
The AD-4C-xx.x card has three card-level LED indicators, described in Table 16-43 .
Table 16-41 AD-4C-xx.x Channel Sets
Band ID Add/Drop Channel IDs
Band 30.3 (A) 30.3, 31.2, 31.9, 32.6
Band 34.2 (B) 34.2, 35.0, 35.8, 36.6
Band 38.1 (C) 38.1, 38.9, 39.7 40.5
Band 42.1 (D) 42.1, 42.9, 43.7, 44.5
Band 46.1 (E) 46.1, 46.9, 47.7, 48.5
Band 50.1 (F) 50.1, 50.9, 51.7, 52.5
Band 54.1 (G) 54.1, 54.9, 55.7, 56.5
Band 58.1 (H) 58.1, 58.9, 59.7, 60.6
Table 16-42 AD-4C-xx.x Port Calibration
Photodiode CTC Type Name Calibrated to Port
P1–P4 ADD COM TX
P5–P8 DROP DROP TX
P9 IN EXP EXP RX
P10 OUT EXP EXP TX
V1 IN COM COM RX
V2 OUT COM COM TX
Table 16-43 AD-4C-xx.x Card-Level Indicators
Card-Level Indicators Description
Red FAIL LED The red FAIL LED indicates that the card’s processor is not ready or that
there is an internal hardware failure. Replace the card if the red FAIL LED
persists.
Green ACT LED The green ACT LED indicates that the AD-4C-xx.x card is carrying traffic
or is traffic-ready.
Amber SF LED The amber SF LED indicates a signal failure or condition. The amber SF
LED also illuminates when the transmit and receive fibers are incorrectly
connected. When the fibers are properly connected, the light turns off.