Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 624 / 1218

11-36
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G213 Change the 32WSS Optical Channel Thresholds
Step 5 Return to your originating procedure (NTP).
DLP-G213 Change the 32WSS Optical Channel Thresholds
Caution
Warning thresholds are not monitored by CTC. They must be user-provisioned and monitored through
custom alarm profiles.
Step 1 In node view, double-click the 32WSS card where you want to change the optical channel optics
threshold settings.
Step 2
Click the Provisioning > Optical Chn: Optical Connector tab for one of the four groups of eight
optical channels that are available.
Step 3 Under Types, choose the type of threshold you want to change, either Warning or Alarm .
Step 4
Click Refresh .
Step 5
Modify any of the warning or alarm threshold settings. Table 11-21 shows the 32WSS optical line
thresholds for warnings. The provisionable parameters are listed in the options column in the table.
Table 11-22 shows the 32WSS optical line thresholds for alarms.
Purpose This task changes the optical channel optics threshold settings for the
32WSS card.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 11-21 32WSS Optical Channel Warning Threshold Settings
Parameter Description Options
Port (Display only) Displays the port number. —
Power Low
(dBm) Set the low power settings. Numeric. Can be set for 15-minute or
one-day intervals. Double-click the
parameter, enter a value, and press
Enter .
Power High
(dBm) Set the high power settings. Numeric. Can be set for 15-minute or
one-day intervals. Double-click the
parameter, enter a value, and press
Enter .