Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 601 / 1218

11-13
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G204 Change Optical Line Settings for OPT-PRE and OPT-BST Amplifiers
Step 3 Modify any of the settings described in Table 11-7 . The provisionable parameters are listed in the
options column in the table.
Table 11-7 OPT-PRE and OPT-BST Amplifier Optical Line Settings
Parameter Description Options
Port # (Display only) Displays the port number. Displays port number and TX or RX.
Port Name Provides the ability to assign the specified port a name. User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press
Enter .
See the “DLP-G104 Assign a Name to a Port” task
on page 7-10 .
Admin State Sets the port service state unless network conditions
prevent the change. For more information about
administrative states, see
Appendix C, “DWDM
Administrative and Service States.”
From the drop-down list, choose one of the
following:
•
IS/Unlocked
• IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan and
import it to the node. From the drop-down list, choose one of the
following:
•
East to West
•
West to East
Service State (Display only) Identifies the autonomously generated
state that gives the overall condition of the port.
Service states appear in the format: Primary
State-Primary State Qualifier, Secondary State. For
more information about service states, see
Appendix C, “DWDM Administrative and Service
States.”
•
IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
•
OOS-MA,DSBLD/Locked-enabled,disabled
•
OOS-MA,MT/Locked-enabled,maintenance
Type (Display only) Identifies the type of port. For OPT-BST cards:
• Input Com
•
Output Com
• Input Line
•
Output Line
•
Input OSC
•
Output OSC
For OPT-PRE cards:
•
Input Com
• Input DCU
•
Output DCU
Power (Display only) Shows the current power level per port. —
AINS Soak (Display only) Shows the soak time. —