2
Installing the CTX2500 Card in the Cisco ONS 15310-MA
78-17333-01
CTX2500 Card Description
The CTX2500 card provides 576 x 576 STS-1 level cross-connections and 2688 x 2688 VT1.5s.
The CTX2500 card can be installed in Slot 3 or 4. Protection switches between the active and standby
CTX 2500 are hitless (less than a 50-ms impact to any traffic).
The CTX2500 supports errorless side switches (switching from one CTX2500 on one side of the shelf
to the other CTX2500 on the other side of the shelf) when the switch is initiated through software or is
caused by a software upgrade.
There are two PPM (SFP) slots on the CTX2500 faceplate. Each slot can contain a one-port PPM.
Cisco-qualified SFPs can be single-rate (OC-3, OC-12, or OC-48) or multirate (OC-3/OC-12).
Single-rate PPMs are autoprovisioned when they are installed, but multirate PPMs must be provisioned.
This behavior can be controlled by NE defaults.
Faceplate and Block Diagram
Figure 1
shows the CTX2500 card faceplate and block diagram.
Figure 1
CTX2500 Faceplate and Block Diagram
145768
ASIC
I2C
LED
RJ45
FP
CRAFT
RJ45
FP
ENET
Bac
kplane Connectors
STS1 XC
TU XC
VT XC
OCN I/F
TIMING
MOD
SCL I/F
ATA I/F
CPU I/F
F
ront P
anel
PLL
VXCO
OCXO
LIU
FPGA
CPLD
ENWT SW
DC/DC
XPT
SW
XPT
SW
SFP1
SFP1
XPT and SFP Control/Status
From Nile2 CPLD
Compact
FLASH
FLASH
DDR
SDRAM
FPGA
BUS
FANOUT
PROCESSOR
TEMP
SFP1/2
IDPROM
REFCLK_IN
REFCLK_OUT
