•
Installing Riser, Type A, on page 23
Installing Riser, Type A
Use this procedure to install a Type A riser onto the PCIe node.
Before you begin
You will find it helpful to get a #2 Phillips screwdriver before you begin.
Step 1
Orient the riser cage with the PCIe node so that the single two thumbscrews are closest to the front of the node.
Step 2
Attach the riser cage to the PCIe node.
a) While lowering the riser cage onto the node, align two guide holes on the cage with their respective guide pins on
the PCIe module.
Make sure that the cables are not pinched by the riser cage.
Note
b) Lower the riser cage onto the PCIe module, making sure to align the thumbscrews with the correct screw holes.
c) Connect the MCIO cable to the rear mezzanine (MEZZ) connector.
d) Connect the power cable to the node's rear motherboard connector.
e) Using a #2 Phillips screwdriver, tighten the three captive thumbscrews to secure the riser cage to the node.
What to do next
Choose the appropriate option:
• Replace another riser cage.
•
Installing a PCIe Node Cover , on page 18
Cisco UCS X440p PCIe Node Installation and Service Guide
23
Servicing the Cisco UCS X440p PCIe Node
Installing Riser, Type A
